Click Here for AirGunHome.com Main Page
Argentina Australia Belgium Canada Chile Denmark France Germany Greece India
Italy Mexico New Zealand Netherlands Norway Russian Federation South Africa Spain Turkey United Kingdom United States
AirGunHome.com: THE Worldwide Airgun Forum


AirGunSeals.com Main Page Link
Air Gun Home Forum Index Register FAQ Memberlist Search

Air Gun Home Forum Index » General Air Gun Questions and Topics » Keeping a QB78 Warm
Post new topic  Reply to topic View previous topic :: View next topic 
Keeping a QB78 Warm 
PostPosted: Thu May 15, 2014 12:41 pm Reply with quote
Alstone
Moderator & Site Supporter
Moderator & Site Supporter
Joined: 01 Mar 2007
Posts: 4139
Location: Linconshire, ENGLAND
One of the problems of using Co2 is the weather and keeping the Co2 warm on a cold day. So after many experiments trying to solve this problem this is my best, and it works.

I bought a pack of hand heaters for using on a motor bike, you wrap them around the hand grips and plug them into the 12v battery, these arrived from China in 5 days for the cost of £2.15p/$1.50, including P&P, Brilliant!

To fit the pads I needed to machine some clearance around the barrel, as these heaters come with some black heat shrink and black electrical tape for fixing, this was a rather delicate operation as I did not want to put the router through the side of the stock.

The next job was to attach one of the heater pads to the Co2 tube, I had already tested it to check the output and loading. The pad was attached to the tube with the electrical tape supplied with the electrical contacts to the outside, then the heat shrink is slid over and heated until it is a tight fit.

I fitted a mini plug and socket to the heater cable and fed it to another connector near the trigger for the exterior power supply. On powering up I set the power to 12v 1 amp, on checking how much the heater was drawing I was quite surprised to find it was 0.6 amp. Trying it out the next night when the outside temperature was down to 6 deg C / 41 deg F, the pressure on the gauge was reading around 700 psi. Turning on the power and leaving the gun for 15 minutes the pressure rose to 900 psi and remained there for the 30 shots I took, Before I packed up I increased the voltage to 14v this pushed the amperage up to 0.7amps and increased the pressure to around 950-1000 psi, so it would suggest that these pads are very voltage dependent, I should point out that at no time were the pads hot to the touch just warm, and not being over powered. I do intend putting a thermister cut out in the circuit this next week

So all in all for the cost of £2.15p/$1.50, a very worth while experiment that looks ok and works on a 12v 12 amp hour battery.

Al



Heater pad


Testing loading


The pads fit nicely around the Co2 tube


Cutting the stock


Pad & heat shrink fitted


Connection for the power cable


Finished

_________________


View user's profile Send private message ICQ Number
Keeping a QB78 Warm 
  Air Gun Home Forum Index » General Air Gun Questions and Topics
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
All times are GMT - 5 Hours  
Page 1 of 1  

  
  
 Post new topic  Reply to topic  

Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.


Click Here for AirGunHome.com Main Page


Powered by phpBB © 2001-2004 phpBB Group
Partial Styling Supplied by Vjacheslav Trushkin Themes Database.