 |  | | | |  |  |  |  | Keeping a QB78 Warm |  | |  |  |  |
Posted: Thu May 15, 2014 12:41 pm |
|
|
| Alstone |
| Moderator & Site Supporter |

 |
 |
| Joined: 01 Mar 2007 |
| Posts: 4139 |
| Location: Linconshire, ENGLAND |
|
|
 |
One of the problems of using Co2 is the weather and keeping the Co2 warm on a cold day. So after many experiments trying to solve this problem this is my best, and it works.
I bought a pack of hand heaters for using on a motor bike, you wrap them around the hand grips and plug them into the 12v battery, these arrived from China in 5 days for the cost of £2.15p/$1.50, including P&P, Brilliant!
To fit the pads I needed to machine some clearance around the barrel, as these heaters come with some black heat shrink and black electrical tape for fixing, this was a rather delicate operation as I did not want to put the router through the side of the stock.
The next job was to attach one of the heater pads to the Co2 tube, I had already tested it to check the output and loading. The pad was attached to the tube with the electrical tape supplied with the electrical contacts to the outside, then the heat shrink is slid over and heated until it is a tight fit.
I fitted a mini plug and socket to the heater cable and fed it to another connector near the trigger for the exterior power supply. On powering up I set the power to 12v 1 amp, on checking how much the heater was drawing I was quite surprised to find it was 0.6 amp. Trying it out the next night when the outside temperature was down to 6 deg C / 41 deg F, the pressure on the gauge was reading around 700 psi. Turning on the power and leaving the gun for 15 minutes the pressure rose to 900 psi and remained there for the 30 shots I took, Before I packed up I increased the voltage to 14v this pushed the amperage up to 0.7amps and increased the pressure to around 950-1000 psi, so it would suggest that these pads are very voltage dependent, I should point out that at no time were the pads hot to the touch just warm, and not being over powered. I do intend putting a thermister cut out in the circuit this next week
So all in all for the cost of £2.15p/$1.50, a very worth while experiment that looks ok and works on a 12v 12 amp hour battery.
Al
Heater pad
Testing loading
The pads fit nicely around the Co2 tube
Cutting the stock
Pad & heat shrink fitted
Connection for the power cable
Finished
 |
|
_________________
 |
|
 |
 |
|
|
|  |  |  | | | |  |  |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|