 |  | | | |  |  |  |  | Unven Breech Seal on Remington Summit Rifle |  | |  |  |  |
Posted: Sat Jan 18, 2014 3:39 pm |
|
|
| Thumb |
| New Member |

|
 |
| Joined: 22 Jun 2013 |
| Posts: 8 |
|
|
|
 |
Tearing down my Remington Summit rifle to replace the srping guide I decided to replace the seals also especially since the breech seal seemed to be bad. Well, I took out the old seal and put in a new one and what do you know, it sat in there just as uneven as the original factory seal. Is this common in these rifles or is something wrong? Here's a couple pics.
Notice how the right side(actually left looking at this pic) is higher than the other side which is flush with the breech.
Same seal looking from the opposite direction. You can see how it is higher on the right side
I looked at the groove where the seal goes in and do not see anything there that would keep the seal from seating. |
|
|
 |
 |
|
|
|  |  |  | | | |  |  |
 |  | | | |  |  |  |  | |  | |  |  |  |
Posted: Sat Jan 18, 2014 4:04 pm |
|
|
| AirGunEric |
| Site Admin |

 |
 |
| Joined: 20 Jan 2007 |
| Posts: 6931 |
| Location: "Out There" |
|
|
 |
That's not "normal". If you do not have anything in the o-ring slot, and the o-ring is even all the way around, perhaps a bit of trimming or shimming would be in order to even things out.
That being said, if you have no air escaping from around the seal when you shoot- leave it alone, it obviously isn't causing an issue. |
|
|
 |
 |
|
|
|  |  |  | | | |  |  |
 |  | | | |  |  |  |  | |  | |  |  |  |
Posted: Sat Jan 18, 2014 9:11 pm |
|
|
| Thumb |
| New Member |

|
 |
| Joined: 22 Jun 2013 |
| Posts: 8 |
|
|
|
 |
I have no idea if there is. When I bought the rifle the seal was like that and after about 6 shots the spring guide broke. I was told it was probably the pellets that I was using were not good and air was escaping around the pellet and that is what made the guide break because it was slamming too hard because of the escaped air around the pellet.
I will be taking it to the range tomorrow to test it out and see what it does. |
|
|
 |
 |
|
|
|  |  |  | | | |  |  |
 |  | | | |  |  |  |  | |  | |  |  |  |
Posted: Tue Jan 21, 2014 2:55 am |
|
|
| Thumb |
| New Member |

|
 |
| Joined: 22 Jun 2013 |
| Posts: 8 |
|
|
|
 |
| Took it out to the range and all seems good, let's see how long it lasts this time. |
|
|
 |
 |
|
|
|  |  |  | | | |  |  |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|