I have a Canadian Crossman 1077 that is rated at 495 fps. 6 or 7 hundred would be nice! What do they do to make this gun so pathetic? Can I order an American valve and then bore it out? Or could I send one of you the factory assembly and you could do it professionaly for me? I'm not an experienced smith. (I don't have access to a press or mill anymore) I found the list of mods on this site but some of the tricks I will not be able to accomplish. Could someone help or point me in the right direction please?
Thanks for your time and assistance.
Warm regards.
Justin E.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
All times are GMT - 5 Hours
Page 1 of 1
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.