 |  | | | |  |  |  |  | |  | |  |  |  |
Posted: Wed Dec 25, 2013 10:34 am |
|
|
| lampy |
| Veteran Member |

 |
 |
| Joined: 04 Aug 2012 |
| Posts: 297 |
| Location: South Dakota |
|
|
 |
|
_________________ Too many projects to list. |
|
 |
 |
|
|
|  |  |  | | | |  |  |
 |  | | | |  |  |  |  | |  | |  |  |  |
Posted: Wed Dec 25, 2013 2:32 pm |
|
|
| Big Bore Bart |
| Member |

|
 |
| Joined: 26 Mar 2013 |
| Posts: 35 |
|
|
|
 |
| ZipSnipe wrote: |
Those steel tubes are pretty stout, I agree with with Bart except I bet its going to be pretty hard . You might be able to do it the way Bart mentions so long as the steel bar that you use is solid. If you have a bench vise with a flat steel anvil section on the back would help. You need a very solid surface to work from.
Also just for your information heating it up wouldn't have worked as the brass would expand before the steel would, but from the look in the pics what others have said about pulling out the front pins ,seems to be the best route. |
Sorry Zip, But the 39x's are all brass, including the pump tube. The steel should be solid, but a piece of pipe will work as long as it's the exact size.  |
|
|
 |
 |
|
|
|  |  |  | | | |  |  |
 |  | | | |  |  |  |  | Re: Filing |  | |  |  |  |
Posted: Wed Dec 25, 2013 3:05 pm |
|
|
| AirGunEric |
| Site Admin |

 |
 |
| Joined: 20 Jan 2007 |
| Posts: 6931 |
| Location: "Out There" |
|
|
 |
| Big Bore Bart wrote: |
| that is one of the high stress points in the rifle, and must be at full thickness. |
I believe that may be a bit of an overstatement- it appears maybe 1/16" is bent out of shape, and the trigger block is really only being stressed by how much the shooter leans on it- otherwise it is retaining the hammer spring pressure on the pin. Unless the tube is out of round up to the cross-pin holes, filing a minimal amount of material on the one edge should not be an issue- the tube does not appear to be damaged much, only what appears to be some flattening of the tube edge and perhaps a slight 'fold'- I'm betting based on that, any attempt to straighten/re-shape with a rod is going to end up doing effectively the same thing, removing a slight amount of material on that edge. |
|
|
 |
 |
|
|
|  |  |  | | | |  |  |
 |  | | | |  |  |  |  | |  | |  |  |  |
Posted: Wed Dec 25, 2013 6:19 pm |
|
|
| t-maxxracer32 |
| New Member |

|
 |
| Joined: 14 Dec 2013 |
| Posts: 7 |
|
|
|
 |
Ill see if we have these tools.
thanks! |
|
|
 |
 |
|
|
|  |  |  | | | |  |  |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|