 |  | | | |  | |  |  | 617x or 622x |  | |  |  | |
 Posted: Sat Aug 31, 2013 12:35 am |
 |
|
| rocketdog1 |
| New Member |
|
|
| Joined: 31 Aug 2013 |
| Posts: 3 |
|
|
|
|
| I've almost completely disassembled my 622x it has the common leak above upper pressure cylinder not the seal where the co2 is seated. My question that's holding me up is the safety. It is the type that can be flipped on either side of the pistol. I don't want to break it, one side has a hole through it. I'm thinking it unthreads, cant find for my life a parts diagram of a 617x or 622x. Does anyone know how to disassemble the safety? Thanks D.M. |
|
Last edited by rocketdog1 on Sun Sep 01, 2013 9:23 pm; edited 1 time in total |
|
|
|
|
|
| |  |  | | | |  |  |
| | | | | | | | | | | | | | |
| Posted: Sat Aug 31, 2013 11:39 am |
|
|
| rocketdog1 |
| New Member |
|
|
| Joined: 31 Aug 2013 |
| Posts: 3 |
|
|
|
|
| Ok found the answer on this site. Nevermind D.M. |
|
|
|
|
|
|
| | | | | | | | |
| | | | | | | | | Thanks | | | | | |
| Posted: Sun Sep 01, 2013 9:33 pm |
|
|
| rocketdog1 |
| New Member |
|
|
| Joined: 31 Aug 2013 |
| Posts: 3 |
|
|
|
|
| Thank You airguneric. The schematic 617xpdf. got me through the repair. The tube keeper on the safety was 3/32". The punch I used was 3/32" and was tight. I think the keeper wasn't that tight but the punch was while trying too push the keeper through. My 1/16" punch went through the keeper. Oh well, the internal cylinder's end cap unthreaded very easy, I wrapped Teflon tape around the threads and tightened it good. Gun doesn't leak at all. Thanks D.M. |
|
|
|
|
|
|
| | | | | | | | |
| | | | | | | | | 617x or 622x | | | | | |
Air Gun Home Forum Index » Pistols
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
All times are GMT - 5 Hours
Page 1 of 1
|
|
|
|
| | | | | | | | |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|
