 |  | | | |  | |  |  | screw & plate? |  | |  |  | |
 Posted: Fri Aug 02, 2013 10:20 am |
 |
|
| boomer92266 |
| Member |
|
|
| Joined: 27 Jul 2013 |
| Posts: 57 |
|
|
|
|
| what is the screw and plate or whats it called on top of my beeman? its at the end on top center, between the scope base grooves. thanks |
|
|
|
|
|
|
| |  |  | | | |  |  |
| | | | | | | | | | | | | | |
| Posted: Fri Aug 02, 2013 10:40 am |
|
|
| oddtodd |
| Silver Status Member |
 |
|
| Joined: 30 Dec 2008 |
| Posts: 2029 |
| Location: Richmond, IN USA |
|
|
|
| Probably your scope stop if there's no hole for a stop in the top between your scope grooves. If you don't have some way of keeping your scope moving backwards it will move and change your POI. That and it will chew up your scope mount and eventually you won't get them to hang in the grooves. Yep, just checked my beeman. That's your scope stop. The back rings of your scope should set against that. |
|
_________________
Airguns: Two starlings talking "Larry, did you hear that? Larry?? LARRY!!!!" |
|
|
|
|
|
| | | | | | | | |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|
