 |  | | | |  |  |  |  | Very inaccurate Crosman 2240 |  | |  |  |  |
Posted: Fri Jul 05, 2013 9:07 pm |
|
|
| swede |
| New Member |

|
 |
| Joined: 28 May 2013 |
| Posts: 2 |
|
|
|
 |
I'm very unhappy with my 2240. It shoots to the right by about 4 inches at 50 feet.I've shot only 3 or 4 CO2 cartridges with it. I have the rear sight completely to the left and it's still way off . Is there anything i can do to make this pistol more accurate? I have a 3576 revolver that is more accurate.
S |
|
Last edited by swede on Sat Jul 06, 2013 9:15 pm; edited 1 time in total |
|
 |
 |
|
|
|  |  |  | | | |  |  |
 |  | | | |  |  |  |  | |  | |  |  |  |
Posted: Sat Jul 06, 2013 3:30 am |
|
|
| Alstone |
| Moderator & Site Supporter |

 |
 |
| Joined: 01 Mar 2007 |
| Posts: 4139 |
| Location: Linconshire, ENGLAND |
|
|
 |
Grab hold of the front sight and twist it slightly to the left, there is always a bit of slack in the fitting, and it probably go knocked out of alignment.
or slacken off the screw in the bottom of the barrel band and twist it a bit to the left, until the gun shoots on target.
BTW Welcome to AirGunHome.
Al |
|
_________________
 |
|
 |
 |
|
|
|  |  |  | | | |  |  |
 |  | | | |  |  |  |  | |  | |  |  |  |
Posted: Sat Jul 06, 2013 1:17 pm |
|
|
| oddtodd |
| Silver Status Member |

 |
 |
| Joined: 30 Dec 2008 |
| Posts: 2029 |
| Location: Richmond, IN USA |
|
|
 |
|
_________________ Airguns: Two starlings talking "Larry, did you hear that? Larry?? LARRY!!!!" |
|
 |
 |
|
|
|  |  |  | | | |  |  |
 |  | | | |  |  |  |  | |  | |  |  |  |
Posted: Sat Jul 06, 2013 9:23 pm |
|
|
| swede |
| New Member |

|
 |
| Joined: 28 May 2013 |
| Posts: 2 |
|
|
|
 |
Thanks guys. I've twisted the front sight to the left abit and centered the rear sight. I'll check it out Monday if I can get to the firing range then.
S |
|
|
 |
 |
|
|
|  |  |  | | | |  |  |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|