 |  | | | |  | |  |  | drop in power air arms s410 |  | |  |  | |
 Posted: Sat Nov 03, 2012 3:37 pm |
 |
|
| spider |
| New Member |
|
|
| Joined: 03 Nov 2012 |
| Posts: 1 |
|
|
|
|
iI bought an Air Arms s410 last Oct 2011 last week I put a few pellets through a chronograph at a local gunsmiths and the power was down below 10ft lb What can I do to rectify this drop in the power
Thank you  |
|
|
|
|
|
|
| |  |  | | | |  |  |
| | | | | | | | | | | | | | |
| Posted: Sun Nov 04, 2012 3:57 pm |
|
|
| Alstone |
| Moderator & Site Supporter |
 |
|
| Joined: 01 Mar 2007 |
| Posts: 4139 |
| Location: Linconshire, ENGLAND |
|
|
|
Welcome to AirGunHome Spider, I would check that you have at least 100 bar presure in the cylinder tube, if so then the problem could be in the valve a defective seal, transfer port or defective spring.
Al |
|
_________________
 |
|
|
|
|
|
| | | | | | | | |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|
