 |  | | | |  | |  |  | cant get co2 into my Walther PPK/s |  | |  |  | |
 Posted: Fri Mar 30, 2012 3:26 am |
 |
|
| joe shmoe |
| New Member |
|
|
| Joined: 30 Mar 2012 |
| Posts: 1 |
|
|
|
|
Hi folks.
I bought a 2nd hand Walther PPK/s. Didnt have any BB or CO2 with it. I looked online and wrongly deduced that it takes 4.5mm BBs.... when infact it takes 6mm, so I am ordering some new BBs.
I also ordered some generic Co2 cylinders, but I cant figure out how to fill the pistol? I can see the little value in the bottom of the Grip (underneath where all the BBs go) but the end of the CO2 cylinder wont fit into the little hole where the valve is. Do I need some kind of adapter or screw-in value?
I dont want to mess about with anything until I am sure of what to do, for safety.
These are the CO2 cylinders that I got. Did I buy the wrong type?
http://www.ebay.co.uk/itm/10-X-CYBERGUN-Co2-CAPSULES-12g-GENUINE-AIR-RIFLE-PISTOL-/130461768628?pt=UK_SportingGoods_Hunting_ShootingSports_ET&hash=item1e60209bb4
Any advice would be great. |
|
|
|
|
|
|
| |  |  | | | |  |  |
| | | | | | | | | | | | | | |
| Posted: Fri Mar 30, 2012 4:19 am |
|
|
| Alstone |
| Moderator & Site Supporter |
 |
|
| Joined: 01 Mar 2007 |
| Posts: 4139 |
| Location: Linconshire, ENGLAND |
|
|
|
Welcome to AirGunHome Joe.
For your gun you need a can of green gas for Airsoft guns, you then fill the gas reservoir in the same part that holds the BBs, the same was as you fill a gas lighter.
You should get around two magazines of BBs from one fill.
Al |
|
_________________
 |
|
|
|
|
|
| | | | | | | | |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|
