 |  | | | |  | |  |  | |  | |  |  | |
 Posted: Fri Aug 19, 2011 7:05 pm |
 |
|
| Plasticman |
| Member |
|
|
| Joined: 06 Apr 2010 |
| Posts: 33 |
|
|
|
|
I haven't checked to see if Eric has one but that is what I will do.
I just hope it doesn't bend again if I put in a new one. |
|
|
|
|
|
|
| |  |  | | | |  |  |
| | | | | | | | | | | | | | |
| Posted: Fri Aug 19, 2011 8:10 pm |
|
|
| SMP |
| Silver Status Member |
 |
|
| Joined: 04 Feb 2011 |
| Posts: 1183 |
| Location: Just south of "Out There"- Land O Lakes Ontario |
|
|
|
| I hope so too. Mine has been fine with 4- 5000 rds through it. I just transfered mine to a buddy because I think I have gone as far as I can go on the Phantom and I'm drooling over my next project. |
|
_________________
Sean
 |
|
|
|
|
|
| | | | | | | | |
| | | | | | | | | | | | | | |
| Posted: Fri Aug 19, 2011 11:24 pm |
|
|
| Plasticman |
| Member |
|
|
| Joined: 06 Apr 2010 |
| Posts: 33 |
|
|
|
|
I think I probably bent it the first few times I pumped it.If so it should be ok.
Good luck on the next project |
|
|
|
|
|
|
| | | | | | | | |
| | | | | | | | | | | | | | |
| Posted: Thu Aug 25, 2011 6:47 pm |
|
|
| Plasticman |
| Member |
|
|
| Joined: 06 Apr 2010 |
| Posts: 33 |
|
|
|
|
| Took the Phantom out after straightening the pump arm. After 60 shots the arm still seems ok. The gun is much easier to pump now than it was for the first 10 or so shots. I my be lucky and not have to get a new arm. |
|
|
|
|
|
|
| | | | | | | | |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|
