 |  | | | |  |  |  |  | Detuning springers for better accuracy. |  | |  |  |  |
Posted: Wed May 21, 2008 9:54 am |
|
|
| cw |
| Banned |
 |
 |
| Joined: 10 Feb 2008 |
| Posts: 1771 |
|
|
|
 |
|
Last edited by cw on Fri Jan 23, 2009 8:16 pm; edited 4 times in total |
|
 |
 |
|
|
|  |  |  | | | |  |  |
 |  | | | |  |  |  |  | I did the same to my B26 |  | |  |  |  |
Posted: Sat May 24, 2008 4:47 pm |
|
|
| cliffspot |
| Veteran Member |

|
 |
| Joined: 15 Jun 2007 |
| Posts: 132 |
| Location: Miami via Hawaii |
|
|
 |
| I put in a synthetic guide and top hat with the stock spring and reduced the stack height about 1/4". It was shooting 935fps out of the box with CPL's, now it's doing 850 fps. I changed the seal to a Maccari unit too, left it a bit tight so that is slowing it down the most I think. Gun is so smooth now! With the trigger job, it feels like a HW! Tempted to play with it more.....but no, it's perfect. |
|
_________________ There are no accidents; only ignorance, mechanical failure, and acts of God! I have loaded over 6 million rounds in the last 5 years and STILL have not seen it all! |
|
 |
 |
|
|
|  |  |  | | | |  |  |
 |  | | | |  |  |  |  | |  | |  |  |  |
Posted: Sat May 24, 2008 7:36 pm |
|
|
| cw |
| Banned |
 |
 |
| Joined: 10 Feb 2008 |
| Posts: 1771 |
|
|
|
 |
|
|
 |
 |
|
|
|  |  |  | | | |  |  |
 |  | | | |  |  |  |  | Cal.... |  | |  |  |  |
Posted: Sun May 25, 2008 1:20 am |
|
|
| cliffspot |
| Veteran Member |

|
 |
| Joined: 15 Jun 2007 |
| Posts: 132 |
| Location: Miami via Hawaii |
|
|
 |
| ..it's 177. Used to torque alot before the tune. I think I need a washer on the front side to get more slip for the spring. |
|
_________________ There are no accidents; only ignorance, mechanical failure, and acts of God! I have loaded over 6 million rounds in the last 5 years and STILL have not seen it all! |
|
 |
 |
|
|
|  |  |  | | | |  |  |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|