| | | | | | | | | "Harris" Hong Kong Bipod? | | | | | |
Posted: Fri Oct 05, 2012 11:12 am |
|
|
Alstone |
Moderator & Site Supporter |
|
|
Joined: 01 Mar 2007 |
Posts: 4139 |
Location: Linconshire, ENGLAND |
|
|
|
I bought a copy of an Harris bipod rest from Hong Kong on E-Bay a while back, first impression was that it was a good buy, until the swivel fell off and I contacted the supplier and complained about it, and to be fair they sent me a new one by airmail. Which broke in the same place on the swivel, and since then I have read about three other people complaining about the same thing.
So what to do about it? I did fasten the swivel boss to the support plate with countersunk screws, which lasted for a while but it eventually broke, And I figured out it was because I was putting strain on it by trying to traverse side to side.
I have now sorted the problem out by adding side traverse to the bipod, this is done by replacing the swivel boss with a square block that can swivel and supports the original top plate with a side traverse connection.
Al |
|
_________________
|
|
|
|
|
|
| | | | | | | | |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|