| | | | | | | | | How hard would it be to cut the barrel on a Umarex Octane | | | | | |
Posted: Sun Aug 17, 2014 11:46 am |
|
|
bradman |
New Member |
|
|
Joined: 12 Aug 2014 |
Posts: 3 |
Location: Old North State NC |
|
|
|
I want to get the barrel on my Umarex Octane cut down about four inches, then add the suppressor back on. Would that be very difficult? What would something like that cost? If anyone has the time to do it shoot me a pm.
Thank you,
Brad |
|
_________________ When life throws you a curve, lean into it!
:-) |
|
|
|
|
|
| | | | | | | | |
| | | | | | | | | | | | | | |
Posted: Sun Aug 17, 2014 1:10 pm |
|
|
AirGunEric |
Site Admin |
|
|
Joined: 20 Jan 2007 |
Posts: 6908 |
Location: "Out There" |
|
|
|
Depends on the configuration of the suppressor setup- if the barrel is vented, you would need a machinist to re-do the vents after shortening it.
That being said, most springers with suppressors do not have vented barrels- the have the basic suppressor housing with some baffles between the muzzle of the actual barrel and the end of the suppressor housing.
If you take off the suppressor to verify the barrel isn't vented, all you would need to do then if not vented is cut the barrel and re-crown, then reinstall the suppressor. |
|
|
|
|
|
|
| | | | | | | | |
| | | | | | | | | | | | | | |
Posted: Mon Aug 18, 2014 7:26 pm |
|
|
bradman |
New Member |
|
|
Joined: 12 Aug 2014 |
Posts: 3 |
Location: Old North State NC |
|
|
|
I see. I'll look into that and see.
Thank you,
Brad |
|
_________________ When life throws you a curve, lean into it!
:-) |
|
|
|
|
|
| | | | | | | | |
| | | | | | | | | | | | | | |
Posted: Fri Oct 10, 2014 6:00 pm |
|
|
Robw |
Veteran Member |
|
|
Joined: 30 Jan 2013 |
Posts: 441 |
|
|
|
|
|
_________________ Getting in a rush only slows you down.
Reflect Jesus Christ-Not your surroundings. |
|
|
|
|
|
| | | | | | | | |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|