 |  | | | |  |  |  |  | let me change the question. |  | |  |  |  |
Posted: Tue May 06, 2014 11:14 am |
|
|
| donwalk |
| Veteran Member |

|
 |
| Joined: 09 Jun 2009 |
| Posts: 247 |
| Location: republik of kaliphornia |
|
|
 |
of an earlier post.
anyone know what sized brass/copper washers to replace the factory plastic pivot washers in a Benjamin NP Trail.
i know i can get the standard plastic ones from crosman, but i want to install the metal ones as i am starting to get the horizontal spread of pellet placement now. |
|
_________________ never squat while wearing spurs...will rogers |
|
 |
 |
|
|
|  |  |  | | | |  |  |
 |  | | | |  |  |  |  | |  | |  |  |  |
Posted: Tue May 06, 2014 7:27 pm |
|
|
| AirGunEric |
| Site Admin |

 |
 |
| Joined: 20 Jan 2007 |
| Posts: 6931 |
| Location: "Out There" |
|
|
 |
| Measure what you've got for ID and OD- the thickness is going to depend on what you are trying to "correct". Typically, brass washers are done for these rifles in 0.55", 0.60" and 0.65" and then "fit" to the specific rifle. |
|
|
 |
 |
|
|
|  |  |  | | | |  |  |
 |  | | | |  |  |  |  | |  | |  |  |  |
Posted: Wed May 07, 2014 6:19 pm |
|
|
| donwalk |
| Veteran Member |

|
 |
| Joined: 09 Jun 2009 |
| Posts: 247 |
| Location: republik of kaliphornia |
|
|
 |
| AirGunEric wrote: |
| Measure what you've got for ID and OD- the thickness is going to depend on what you are trying to "correct". Typically, brass washers are done for these rifles in 0.55", 0.60" and 0.65" and then "fit" to the specific rifle. |
thanks...that's all i need |
|
_________________ never squat while wearing spurs...will rogers |
|
 |
 |
|
|
|  |  |  | | | |  |  |
 |  | | | |  |  |  |  | let me change the question. |  | |  |  |  |
Air Gun Home Forum Index » Rifles
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
All times are GMT - 5 Hours
Page 1 of 1
|
|
|
|
|  |  |  | | | |  |  |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|