 |  | | | |  | |  |  | how to remove spring on a beeman RS2 |  | |  |  | |
 Posted: Wed Jul 31, 2013 1:04 pm |
 |
|
| boomer92266 |
| Member |
|
|
| Joined: 27 Jul 2013 |
| Posts: 57 |
|
|
|
|
| i recently purchased a beeman wolverine RS2, i'm getting and extra spring and seals in case i need them. i was looking at the gun this morning and i'm not sure how to remove the spring, it seems that the back of the spring is resting against the trigger assembly. if the trigger assembly is removed then the spring will fly out. i can't figure a way to get anything in there to compress the spring with the trigger assembly still in. i know i might should wait till i need to do this to ask, but i thought i would go ahead so i could get the necessary parts and equipment. thanks for any help |
|
|
|
|
|
|
| |  |  | | | |  |  |
| | | | | | | | | | | | | | |
| Posted: Wed Jul 31, 2013 2:46 pm |
|
|
| oddtodd |
| Silver Status Member |
 |
|
| Joined: 30 Dec 2008 |
| Posts: 2029 |
| Location: Richmond, IN USA |
|
|
|
| Dude, unless you break a spring tomorrow(which then it would be under warranty) You won't have to pull that down for 20 years or more. Even so, post a pic and I will see what I can tell you. |
|
_________________
Airguns: Two starlings talking "Larry, did you hear that? Larry?? LARRY!!!!" |
|
|
|
|
|
| | | | | | | | |
| | | | | | | | | Re: how to remove spring on a beeman RS2 | | | | | |
| Posted: Fri Aug 02, 2013 4:30 pm |
|
|
| Griff1950 |
| Member |
|
|
| Joined: 29 Apr 2009 |
| Posts: 72 |
| Location: Arkansas |
|
|
|
| boomer92266 wrote: |
| i recently purchased a beeman wolverine RS2, i'm getting and extra spring and seals in case i need them. i was looking at the gun this morning and i'm not sure how to remove the spring, it seems that the back of the spring is resting against the trigger assembly. if the trigger assembly is removed then the spring will fly out. i can't figure a way to get anything in there to compress the spring with the trigger assembly still in. i know i might should wait till i need to do this to ask, but i thought i would go ahead so i could get the necessary parts and equipment. thanks for any help |
The RS2 is a bit troublesome. You have to make a 4-pronged plug that will fit in past the trigger mechanism. Most make it by grinding slots in a hex-nut socket that will fit inside the hole. |
|
|
|
|
|
|
| | | | | | | | |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|
