 |  | | | |  | |  |  | Powerline 5170 questions. |  | |  |  | |
 Posted: Thu Feb 16, 2012 8:22 pm |
 |
|
| cnrcpla |
| New Member |
|
|
| Joined: 16 Feb 2012 |
| Posts: 2 |
| Location: USA |
|
|
|
I'm new here, so forgive me if this isn't the right place for this post. But, I have a daisy powerline 5170 pistol. It has the extended barrel on it, but I was wondering if there was any way to remove it? Preferably without cutting it off  Thanks. |
|
|
|
|
|
|
| |  |  | | | |  |  |
| | | | | | | | | | | | | | |
| Posted: Fri Feb 17, 2012 5:24 am |
|
|
| Alstone |
| Moderator & Site Supporter |
 |
|
| Joined: 01 Mar 2007 |
| Posts: 4139 |
| Location: Linconshire, ENGLAND |
|
|
|
Welcome to AirGunHome cnrcpla.
Provided the barrel does not go to the end of the extension it should be ok, but make sure the bit you cut off is not retaining the barrel.
If the barrel goes to the end I should leave it alone.
Al |
|
_________________
 |
|
|
|
|
|
| | | | | | | | |
| | | | | | | | | | | | | | |
| Posted: Fri Feb 17, 2012 7:58 am |
|
|
| cnrcpla |
| New Member |
|
|
| Joined: 16 Feb 2012 |
| Posts: 2 |
| Location: USA |
|
|
|
| Thanks The barrel does not go into the extension, but I would rather not cut it off, so if there isn't a way to remove it properly, then I will leave it be. |
|
|
|
|
|
|
| | | | | | | | |
| | | | | | | | | Powerline 5170 questions. | | | | | |
Air Gun Home Forum Index » Pistols
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
All times are GMT - 5 Hours
Page 1 of 1
|
|
|
|
| | | | | | | | |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|
