 |  | | | |  |  |  |  | Custom Stocks...any suggestions? RWS AM850 |  | |  |  |  |
Posted: Sat Nov 17, 2007 2:51 am |
|
|
| jjensen6387 |
| Member |

 |
 |
| Joined: 14 Nov 2007 |
| Posts: 13 |
| Location: Crookston, MN |
|
|
 |
So im lookin to put a custom stock on my RWS AM 850, what do all of you "Experts" for ideas? I just want to get a wood stock that fits my .177 and is a thumb hole, unfinished finish so I can paint it myself...any suggestions? THANKS GUYS
Kinda like this, but for the AM850 and unfinished:
MFR with walnut CS800 stock installed shown below
 |
|
_________________ Josh "Skinny" Jensen
Owner/Operator:
Crappie Junction: Custom Rods
"OSK or don't shoot at all!!" |
|
 |
 |
|
|
|  |  |  | | | |  |  |
 |  | | | |  |  |  |  | |  | |  |  |  |
Posted: Sat Nov 17, 2007 8:15 am |
|
|
| AirGunEric |
| Site Admin |

 |
 |
| Joined: 20 Jan 2007 |
| Posts: 6929 |
| Location: "Out There" |
|
|
 |
Is anyone out there even making stocks for the AM850 at this point? I would think because it and the Dominator 1250 being on the same basic platform somebody would do it, if just for people and the 1250- but it hasn't been sold for very long in the U.S. (is it even being sold in the U.S. yet?). You may have to do it yourself from the ground-up!  |
|
|
 |
 |
|
|
|  |  |  | | | |  |  |
 |  | | | |  |  |  |  | |  | |  |  |  |
Posted: Sat Nov 17, 2007 11:07 am |
|
|
| jjensen6387 |
| Member |

 |
 |
| Joined: 14 Nov 2007 |
| Posts: 13 |
| Location: Crookston, MN |
|
|
 |
| That sounds like a fun project... could some one point me in the right direction for doing that?...Online references, books, ect. that could help me with fitting my gun into a new stock... post it up cause i think I just found myself a new obsession with these air guns; my Gf and I are going to start comp. shooting when we get around to getting some nice guns for it and I start figuring out all the basics.... THANKS ALL |
|
_________________ Josh "Skinny" Jensen
Owner/Operator:
Crappie Junction: Custom Rods
"OSK or don't shoot at all!!" |
|
 |
 |
|
|
|  |  |  | | | |  |  |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|