 |  | | | |  | |  |  | Drilling Ruger Elite |  | |  |  | |
 Posted: Fri Dec 31, 2010 11:18 am |
 |
|
| bobbyt67 |
| New Member |
|
|
| Joined: 31 Dec 2010 |
| Posts: 1 |
| Location: USA |
|
|
|
| Is it possible to drill and tap receiver for scope mounts. The dove tail groves will not hold scope mounts at all,,pop loose evry three shots or so. |
|
|
|
|
|
|
| |  |  | | | |  |  |
| | | | | | | | | | | | | | |
| Posted: Fri Dec 31, 2010 12:53 pm |
|
|
| AirGunEric |
| Site Admin |
 |
|
| Joined: 20 Jan 2007 |
| Posts: 6930 |
| Location: "Out There" |
|
|
|
Why not try a different set of mounts? The Ruger is not that powerful- so unless the rails have been machined incorrectly- it's likely the mounts are not grabbing correctly.
As for drilling the tube- perhaps a hole to hold a stop-pin for a mount with one on it- but I don't know how much "meat" is there so screws might not be a good idea... |
|
|
|
|
|
|
| | | | | | | | |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|
