 |  | | | |  | |  |  | Smooth Bolt Action on a QBxx |  | |  |  | |
 Posted: Wed Aug 29, 2007 12:01 pm |
 |
|
| Alstone |
| Moderator & Site Supporter |
 |
|
| Joined: 01 Mar 2007 |
| Posts: 4139 |
| Location: Linconshire, ENGLAND |
|
|
|
The bolt on the QB series of guns is quite stiff when new, to make it a lot smoother you need to polish all the mating parts of the action, including the tubes.
To polish tubes cut a piece of dowelling the length of the tube, cut a slot in the end about 25mm deep, get a length of fine emery about 6-8 inches long put one end in the slot and roll it round the dowel, put the other end in a drill and away you go.
Grease well and the bolt should be as smooth as silk.
Al |
|
|
|
|
|
|
| |  |  | | | |  |  |
| | | | | | | | | | | | | | |
| Posted: Wed Aug 29, 2007 12:25 pm |
|
|
| AirGunEric |
| Site Admin |
 |
|
| Joined: 20 Jan 2007 |
| Posts: 6930 |
| Location: "Out There" |
|
|
|
Those are some solid looking internals for a Co² gun.
Al's new hobby is polishing! |
|
|
|
|
|
|
| | | | | | | | |
| | | | | | | | | Smooth Bolt Action on a QBxx | | | | | |
Air Gun Home Forum Index » Rifles
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
All times are GMT - 5 Hours
Page 1 of 1
|
|
|
|
| | | | | | | | |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|
