 |  | | | |  | |  |  | just a pic |  | |  |  | |
 Posted: Mon Nov 23, 2009 12:52 am |
 |
|
| kanyon |
| Silver Status Member |
|
|
| Joined: 09 Aug 2008 |
| Posts: 1582 |
| Location: New Zealand |
|
|
|
Needed to start a new project to finish one...
needed a mill..Thought it would be something abit diffrent
from air guns to make one....
The head will rotate when built....The berring head I made years ago
for a linisher.....it will be mounted on a 40mm shaft with the motor
on the other end...the whole unit will rotate as a unit though clamping blocks on the top of the column....
It has a MT2 tapper in it with a hole for a draw bolt to take
a collet chuck..................
Pete |
|
|
|
|
|
|
| |  |  | | | |  |  |
| | | | | | | | | | | | | | |
| Posted: Mon Nov 23, 2009 4:53 am |
|
|
| Alstone |
| Moderator & Site Supporter |
 |
|
| Joined: 01 Mar 2007 |
| Posts: 4139 |
| Location: Linconshire, ENGLAND |
|
|
|
Nice one Pete, whats the gearbox at the bottom for lift or rotation?
Al |
|
_________________
 |
|
|
|
|
|
| | | | | | | | |
| | | | | | | | | | | | | | |
| Posted: Tue Nov 24, 2009 1:06 am |
|
|
| kanyon |
| Silver Status Member |
|
|
| Joined: 09 Aug 2008 |
| Posts: 1582 |
| Location: New Zealand |
|
|
|
| Alstone wrote: |
Nice one Pete, whats the gearbox at the bottom for lift or rotation?
Al |
It for the table lifter....
Its a 100:1....25:1 is what I had in mined
but it was free..... 
but it will give very fine adjustments.....
the unit below was MK1.....Had a change of mined and desided to
got to a floor stand unit....liftrers the same...
 |
|
|
|
|
|
|
| | | | | | | | |
| | | | | | | | | | | | | | |
| Posted: Wed Dec 02, 2009 12:10 pm |
|
|
| donwalk |
| Veteran Member |
|
|
| Joined: 09 Jun 2009 |
| Posts: 247 |
| Location: republik of kaliphornia |
|
|
|
not bad...not bad at all...  |
|
_________________
never squat while wearing spurs...will rogers |
|
|
|
|
|
| | | | | | | | |
| | | | | | | | | just a pic | | | | | |
Air Gun Home Forum Index » Picture Gallery
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
All times are GMT - 5 Hours
Page 1 of 1
|
|
|
|
| | | | | | | | |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|
