 |  | | | |  | |  |  | Gauge on Discovery Pump is 1/8"-28 BSP thread |  | |  |  | |
 Posted: Sun Oct 04, 2009 11:47 pm |
 |
|
| rsterne |
| Moderator |
 |
|
| Joined: 15 Jan 2008 |
| Posts: 2998 |
| Location: Coalmont, BC |
|
|
|
In case anyone is interested, the thread on the gauge on the Disco pump is 1/8"-28 BSP.... that means it is the same as the one on a Hill or AirForce pump.... It threads quite easily into a 1/8"-27 NPT hole and although I haven't tried it yet, should seal fine with teflon thread tape.... With a 1/4" engagement, it's only out 1/4 thread in pitch.... 
Doing it the other way.... ie threading a 1/8"-27 NPT fitting into the hole on the Disco pump is a tighter fit, but I think it will still work.... From what I have read, you can do this installation ONCE.... but it may ruin the threads.... 
If you need a replacement gauge for your Disco pump, a Hill or AirForce gauge should fit perfectly.... 
Bob |
|
_________________
Dominion Marksman Silver Shield - 5890 x 6000 in 1976, and downhill ever since!
Airsonal: Too many to count! |
|
|
|
|
|
| |  |  | | | |  |  |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|
