 |  | | | |  | |  |  | UGLY real ugly |  | |  |  | |
 Posted: Sat May 09, 2009 5:16 pm |
 |
|
| kanyon |
| Silver Status Member |
|
|
| Joined: 09 Aug 2008 |
| Posts: 1582 |
| Location: New Zealand |
|
|
|
Pulled the Hatsan apart... what a mess..these things are built real cheap..
even the B11 copys are way better built...
note..the spring ends are not finished and have cut a groove
around the inside of the piston and the same on the rear guide
thrust washer...
There is NO top hat/front guide ..the spring just runs against
the piston....
A complete new guide system is in the making..
 |
|
|
|
|
|
|
| |  |  | | | |  |  |
| | | | | | | | | | | | | | |
| Posted: Sat May 09, 2009 8:55 pm |
|
|
| AirGunEric |
| Site Admin |
 |
|
| Joined: 20 Jan 2007 |
| Posts: 6931 |
| Location: "Out There" |
|
|
|
| Is it possible the spring had been cut by someone before you got it? I had a couple of replacement Hatsan springs awhile back and they were fairly well finished on the ends. No guide is definitely not good! |
|
|
|
|
|
|
| | | | | | | | |
| | | | | | | | | | | | | | |
| Posted: Sun May 10, 2009 11:57 pm |
|
|
| kanyon |
| Silver Status Member |
|
|
| Joined: 09 Aug 2008 |
| Posts: 1582 |
| Location: New Zealand |
|
|
|
| AirGunEric wrote: |
| Is it possible the spring had been cut by someone before you got it? I had a couple of replacement Hatsan springs awhile back and they were fairly well finished on the ends. No guide is definitely not good! |
Its possable someone has had a play in there...its a multi sear trigger
so it one of there later guns/early ones were single sear "B11"....
I need a parts brake down to see if the bits match.... With the amount of weight in the piston a new front guide will have to be light , with some weight removed from the piston to retaine the same moveing mass weight.
The real prob is going to be the rear guide...As the guide/end plug also carrys the saftey...Some time in the mill to duplarcate it in stainless , would like to do it in alloy but not sure if a 10mm guide shaft would be strong enough in alloy..10mm as I want to sleve it with nylon....
Anyway this thing won't be the same gun when it shoots its next pellet.
Pete |
|
|
|
|
|
|
| | | | | | | | |
| | | | | | | | | UGLY real ugly | | | | | |
Air Gun Home Forum Index » Picture Gallery
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
All times are GMT - 5 Hours
Page 1 of 1
|
|
|
|
| | | | | | | | |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|
