 |  | | | |  | |  |  | Thinking Of ordering the gas ram for my .22 Whisper |  | |  |  | |
 Posted: Fri Apr 17, 2009 12:33 am |
 |
|
| Mark5043 |
| Silver Status Member |
 |
|
| Joined: 12 Apr 2009 |
| Posts: 1379 |
|
|
|
|
Heard a-lot of good things about the gas ram conversion for the Gamo whisper.Problem is that Airgun Depot says they don't come with installation instructions,and Iv'e never torn down a springer before.I have looked on the internet to find instructions to no avail.How hard is this conversion to do?  |
|
|
|
|
|
|
| |  |  | | | |  |  |
| | | | | | | | | Re: Thinking Of ordering the gas ram for my .22 Whisper | | | | | |
| Posted: Fri Apr 17, 2009 12:42 am |
|
|
| Mark5043 |
| Silver Status Member |
|
|
| Joined: 12 Apr 2009 |
| Posts: 1379 |
|
|
|
|
| Mark5043 wrote: |
| Heard a-lot of good things about the gas ram conversion for the Gamo whisper.Problem is that Airgun Depot says they don't come with installation instructions,and Iv'e never torn down a springer before.I have looked on the internet to find instructions to no avail.How hard is this conversion to do? |
I stand corrected.It was pyramid air that says the gas rams come with no instructions.Anyone know where I can get these instructions to do this conversion? |
|
|
|
|
|
|
| | | | | | | | |
| | | | | | | | | Re: Thinking Of ordering the gas ram for my .22 Whisper | | | | | |
| Posted: Fri Apr 17, 2009 12:58 am |
|
|
| kanyon |
| Silver Status Member |
|
|
| Joined: 09 Aug 2008 |
| Posts: 1582 |
| Location: New Zealand |
|
|
|
| Mark5043 wrote: |
| Mark5043 wrote: |
| Heard a-lot of good things about the gas ram conversion for the Gamo whisper.Problem is that Airgun Depot says they don't come with installation instructions,and Iv'e never torn down a springer before.I have looked on the internet to find instructions to no avail.How hard is this conversion to do? |
I stand corrected.It was pyramid air that says the gas rams come with no instructions.Anyone know where I can get these instructions to do this conversion? |
Its straight forward...pull it apart toss some bits and toss the ram in....
really NO big drama.....BUT use a spring compresser....The first thing is after you have removed the stock then take the trigger unit out....as the spring will not come out till the trigger unit is removed....the rear stock bolt holds the trigg...so after the stock is off just slide the trigg unit rearwards and it will lift out....the rest is easy |
|
|
|
|
|
|
| | | | | | | | |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|
