 |  | | | |  | |  |  | Reg setup |  | |  |  | |
 Posted: Sun Jan 25, 2009 7:19 pm |
 |
|
| FrankG |
| Member |
|
|
| Joined: 18 Jan 2009 |
| Posts: 12 |
|
|
|
|
Hi,
I am planning a build with a Crosman AS2250XT.I have asked JDSAirman if he could make me a setup with one of his small tank with a reg set for an output of 1000 Psi.I told him I was gonna be using the stock hardware.He said the burst disk would be 1.7K.I was thinking of a 1.2K burst disk.I know he probably know for sure what he is doing a lot more than me.
But what you guys are you thinking of it? |
|
|
|
|
|
|
| |  |  | | | |  |  |
| | | | | | | | | | | | | | |
| Posted: Sun Jan 25, 2009 9:21 pm |
|
|
| yourdaddyjoe |
| Supporting Member |
 |
|
| Joined: 26 May 2008 |
| Posts: 4027 |
| Location: Tatorville, USA |
|
|
|
1.7k or 1.8k is optimal for HPA or Co2 system. I recomend using them with my Direct Injection Systems down stream from the tank.
It is all for your protection if the Regulator ever fails. |
|
|
|
|
|
|
| | | | | | | | |
| | | | | | | | | Reg setup | | | | | |
Air Gun Home Forum Index » Rifles
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
All times are GMT - 5 Hours
Page 1 of 1
|
|
|
|
| | | | | | | | |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|
