 |  | | | |  | |  |  | 1377 pump arm |  | |  |  | |
 Posted: Tue Oct 07, 2008 5:17 pm |
 |
|
| Pie Man |
| Member |
 |
|
| Joined: 13 May 2008 |
| Posts: 56 |
|
|
|
|
| Hey guys i have a crossman 1377 and was thinking about getting a set of wood grips and pump arm. I know how to change grips but I dont know how to change to the pump arm? Is it hard or does it just take a couple of minutes? All the help would be great. |
|
|
|
|
|
|
| |  |  | | | |  |  |
| | | | | | | | | | | | | | |
| Posted: Tue Oct 07, 2008 6:54 pm |
|
|
| AirGunEric |
| Site Admin |
 |
|
| Joined: 20 Jan 2007 |
| Posts: 6929 |
| Location: "Out There" |
|
|
|
The pump arm on a stock 1322/1377 is held in by two pins- i.e. a friction fit. Drive them out, remove pump handle (not 'arm'- this would be more the steel lever that pushes the piston), put new one on and drive the pins back in.
Personally, if I were going to customize one with wood grips and pump handle- I'd probably drill the lever to use screws or bolts and then expand the holes on the pump handle as well to fit them. |
|
|
|
|
|
|
| | | | | | | | |
| | | | | | | | | | | | | | |
| Posted: Tue Oct 07, 2008 11:02 pm |
|
|
| Slavia |
| Moderator |
 |
|
| Joined: 31 Mar 2008 |
| Posts: 4382 |
| Location: Waseca, Minnesota, USA |
|
|
|
| Or maybe tap the holes in the metal pump arm to hold screws coming through the wooden pump handle. |
|
_________________
 ¡Listo! ¡Apunte! ¡Fuego! |
|
|
|
|
|
| | | | | | | | |
| | | | | | | | | 1377 pump arm | | | | | |
Air Gun Home Forum Index » Pistols
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
All times are GMT - 5 Hours
Page 1 of 1
|
|
|
|
| | | | | | | | |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|
