| | | | | | | | | Is the sight blade on a 39x removeable? | | | | | |
Posted: Fri Jul 15, 2016 11:18 am |
|
|
domer_pyle |
Senior Member |
|
|
Joined: 17 Sep 2009 |
Posts: 523 |
|
|
|
|
If it's not too much of a chore I'd like to remove it for the shroud/brake project I'm in the middle of |
|
|
|
|
|
|
| | | | | | | | |
| | | | | | | | | | | | | | |
Posted: Fri Jul 15, 2016 12:30 pm |
|
|
Robw |
Veteran Member |
|
|
Joined: 30 Jan 2013 |
Posts: 441 |
|
|
|
|
I believe that those are brass guns, soldered together. So maybe it
is soldered on. |
|
_________________ Getting in a rush only slows you down.
Reflect Jesus Christ-Not your surroundings. |
|
|
|
|
|
| | | | | | | | |
| | | | | | | | | | | | | | |
Posted: Sun Jul 17, 2016 11:41 am |
|
|
domer_pyle |
Senior Member |
|
|
Joined: 17 Sep 2009 |
Posts: 523 |
|
|
|
|
I'll have to scratch at the paint a bit at the seam a little bit and check |
|
|
|
|
|
|
| | | | | | | | |
| | | | | | | | | | | | | | |
Posted: Sat Oct 22, 2016 8:46 pm |
|
|
domer_pyle |
Senior Member |
|
|
Joined: 17 Sep 2009 |
Posts: 523 |
|
|
|
|
Haven't gotten around to removing it just yet, but figured I'd chime in quick since having messed with the sight a bit. It seem to slide onto the barrel and butt up to the pump tube on both sides where it's soldered to the pump tube. So it should be a pretty easy task, hopefully |
|
|
|
|
|
|
| | | | | | | | |
| | | | | | | | | | | | | | |
Posted: Thu Jul 27, 2017 5:30 pm |
|
|
domer_pyle |
Senior Member |
|
|
Joined: 17 Sep 2009 |
Posts: 523 |
|
|
|
|
Ten seconds with MAPP gas and it taps right off. Be warned, you'll heat up the front end of your gun a bit so it's not a bad idea to wrap a wet rag around the barrel and pump tube just behind the sight |
|
|
|
|
|
|
| | | | | | | | |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|