 |  | | | |  |  |  |  | Bad cylinder. |  | |  |  |  |
Posted: Sat Jan 17, 2015 2:26 pm |
|
|
| Robw |
| Veteran Member |

|
 |
| Joined: 30 Jan 2013 |
| Posts: 441 |
|
|
|
 |
I just acquired a B3-2 that has a bad cylinder. The little tab that the loading
link engages has broken so that the loading link has nothing to grab to push
the cylinder back. I can not locate a new or used one anywhere.
I was wonder if I could just weld a new tab in. Any thoughts?
Thanks, Rob. |
|
_________________ Getting in a rush only slows you down.
Reflect Jesus Christ-Not your surroundings. |
|
 |
 |
|
|
|  |  |  | | | |  |  |
 |  | | | |  |  |  |  | |  | |  |  |  |
Posted: Sat Jan 17, 2015 6:17 pm |
|
|
| AirGunEric |
| Site Admin |

 |
 |
| Joined: 20 Jan 2007 |
| Posts: 6931 |
| Location: "Out There" |
|
|
 |
| Cuuld give it a try- the B3 is not exactly a high-end piece, so it's not like you'll be feeling too bad if it goes wrong. That being said,be sure the lock works so you don't lose a finger loading it. |
|
|
 |
 |
|
|
|  |  |  | | | |  |  |
 |  | | | |  |  |  |  | |  | |  |  |  |
Posted: Sat Jan 17, 2015 6:37 pm |
|
|
| Robw |
| Veteran Member |

|
 |
| Joined: 30 Jan 2013 |
| Posts: 441 |
|
|
|
 |
I have a hole drilled in the receiver that a piece of drill steel is inserted into in
front of the cylinder before I put the tips of my fingers in the loading bay. |
|
_________________ Getting in a rush only slows you down.
Reflect Jesus Christ-Not your surroundings. |
|
 |
 |
|
|
|  |  |  | | | |  |  |
 |  | | | |  |  |  |  | Bad cylinder. |  | |  |  |  |
Air Gun Home Forum Index » Rifles
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
All times are GMT - 5 Hours
Page 1 of 1
|
|
|
|
|  |  |  | | | |  |  |
Note: If you are seeing "Please enter your username and password to log in." Your browser cookies have been reset
or you need to register to access the topic in question. Use the 'Register' button near the top left of this page.
|